Ezifit series filters are so easy to change and maintain. No more under sink mess.

• Turn water off at the mini valve under sink – leave faucet in the ON position.
• Read changing instructions in the package to make sure of the filter order.
• Have ezifit fitting tool (Small spanner) ready

    PLEASE NOTE: Click images for more detail

1. Slide spanner onto TOP of the filter around stem BELOW the white or gray coloured insert in the elbow.
2. Lever spanner upwards pushing the insert up into the elbow until grey elbow slides off filter stem.
3. Use spanner as lever until the elbow slides off
   IMPORTANT
   Spanner is between filter and under the insert in the elbow, NOT between insert and elbow.
4. Repeat process at the bottom elbow of the filter.
5. If you are changing more than one filter, then simply repeat the above process.
   
   
        PLEASE NOTE: Click images for more detail
   
   
   
   
6. Hold lower part of the filter and remove old filter from bracket and clip on new filters firmly.
7. Remove protection caps from filters Push grey elbows you removed first back onto both ends of filters.
   IMPORTANT
   Make sure hoses are pushed firmly into the elbows and the elbows are
   pushed firmly onto the filters. If loose, could cause leakage.
   
   
   
   
8. Make sure the purifier faucet on your sink is in ON position
9. Run your filter for 1-2minutes after changing to flush out the system
   IMPORTANT
   Turn water supply off under the sink if not being used for long term and flush water for a few minutes ,when you turn back after long period off
   Do not run hot water through your filter system

© Copyright 2008 BIOPURE All rights reserved | Top of Page | Contact Us